Evolv 28461 Manual del operador descargar pdf (Pagina 18)

TO INSTALL THE HANDLE

See Figure 9.

[] Hold the nylon nut securely and turn the screw

counter- clockwise to remove the nut completely.

NOTE: Do not remove the screw from the handle.

[] Place the nylon nut into the recessed hole on the back

of the height/bevel adjusting handwheel and hold in

place.

[] Slide the handle, screw, and washer into the hole on

the height/bevel adjusting handwheel.

[] Using a flathead screwdriver, turn the screw clockwise

and tighten in place.

HANDLE

SCREW

NYLON HEIGHT/ BEVEL

NUT ADJUSTINGHANDWHEEL

Fig. 9

TO INSTALL THE LOCKING LEVER

See Figure 10.

[] Slide the locking lever over the exposed end of the rip

fence making certain the handle is inserted as far as

possible.

[] Align the holes in the rip fence and the holes in the

lever. Secure using the screws.

RiP

FENCE

LOCKING

LEVER

SCREWS

Fig. 10

TO REMOVE/REPLACE THE THROAT PLATE

See Figure 11.

[] Lower the blade by turning the height/bevel adjusting

handwheel counterclockwise.

[] To remove the throat plate, place your index finger in

the hole and liftthe front end pulling the throat plate

out toward the front of the saw.

[] To reinstall the throat plate, slip the tab into the slot at

the back of the saw and push down to secure in place.

THROAT

PLATE

SPREADER/ RiViNG

KNIFE

®@

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Comentarios a estos manuales

Sin comentarios

Evolv 28461 Manual del operador Pagina 18

Comentarios a estos manuales