Evolv 28461 Manual del operador descargar pdf (Pagina 19)

TO CHANGE BETWEEN A SPREADER AND A

RiViNG KNIFE

See Figure 12.

This saw is shipped with the spreader/riving knife placed

in the non-through cutting or "down" position (riving knife

position).

NOTE: The spreader/riving knife must be placed in the

through cutting, or "up" position (spreader position), for all

other cutting operations.

[] Unplug the saw.

To place in spreader position (or "up" position for all

through cutting):

[] Remove the throat plate.

[] Raise the saw blade by turning the height/bevel

adjusting handwheel clockwise.

[] Unlock the release lever by pulling it up.

[] Grasp the spreader and pull it towards the right side of

the saw to release the spreader from the spring-loaded

riving clamp.

[] Pull the spreader up until the internal pins are engaged

and the spreader is above the saw blade.

[] Lock the release lever by pushing the lever down.

[] Reinstall the throat plate.

To place in riving knife position (or "down" position for

all non=through cutting):

[] Remove the throat plate.

[] Raise the saw blade by turning the height/bevel

adjusting handwheel clockwise.

[] Unlock the release lever by pulling it up.

[] Push the riving knife down until it is below the saw

blade.

[] Lock the release lever by pushing the lever down.

[] Reinstall the throat plate.

_"-=-"_---_ _ RELEASELEVER

\ (UNLOCKED)

IN"UP" POSITIONFORTHROUGHCUTTING

RELEASELEVER

(LOCKED)

IN "DOWN"POSITIONFORNON-THROUGHCUTTING

Fig. 12

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Sin comentarios

Evolv 28461 Manual del operador Pagina 19